Cisco pass4sure LAB
CISCO: ccnp 642-825 lab Q
Acme is a small export comany that has an existing enterprise network that is made up exclusively of routers that are using EIGRP as the IGP. Their network is up and operating properly. As part of their network expansion, Acme has decided to connect t...
CISCO: ccnp 642-825 lab Q
Acme is a small export comany that has an existing enterprise network that is made up exclusively of routers that are using EIGRP as the IGP. Their network is up and operating properly. As part of their network expansion, Acme has decided to connect t...
CCIE 350-001-Lab Pass4sure freedown
Pass4sure will update exam 350-001-Lab next week, and add six sets of bibles. We are building the new exam right now, but here we provide one set of classical
160 as free demo for you to try first!
If you want more,please login pass4sure w...
TO Simulate WAN Environment with VMWARE and Dynamips
Dynamips, also known as “Cisco 7200 Simulator”, achieves simulation by simulating hardware, which is similar to VMware. It also supports NIC bridging mode, thus realize communication with Ethernet cards of the host. With OmniPeek you can s...
CCNA Lab2 Set Router Port Address/Label and Save Settings
Lab Requirements: Lab Requirements: Download address: CCNA lab1 Change Router Name and Password As many customers haved mensioned that there are few lab Q&As in 640-802, here we decide to offer lab video after discussion. You can download them on our website. Currently those lab videos are in preparation. As many customers haved mensioned that there are few lab Q&As in 640-802, here we decide to offer lab video after discussion. You can download them on our website. Currently those lab videos are in preparation. Download: eigrp.zip Lab requirements: enable EIFRP protocol, and ask for entire network accessible Download:nat.zip Lab requirements: configure NAT so that internal network is able to access internet
1. On the router port, set the IP address to 202.119.249.219 and mask to 255.255.255.0.
2. Set the router prompt message to welcome to router CCNAlab.
3 Set the router port prompt message to this is a serial port
CCNA lab1 Change Router Name and Password
1. Router name: router
2. Set password to cisco, sercret to cisco, and vty to cisco.
3 All the passwords are required to be encrypted
CCNA:Lab 2 CDP command operation
For those who are going to tak...
CCNA:lab01 The basic operation of the router
For those who are going to tak...
CCNA:pass4sure cisco lab—EIGRP routing protocol
Lab topology:
Lab steps:
P4S-R1(config)#int lo 0
P4S-R1(config-if)#ip address 10.1.1.1 255.255.255.0
P4S-R1(config-...
CCNA:pass4sure cisco lab NAT configure
Lab topology:
Lab requirements:
PC-1(config)#int f0/0
PC-1(config-if)#ip address 10.1.1.1 255.255.255.0
PC-1(conf...