CCNA LAB
TO Simulate WAN Environment with VMWARE and Dynamips
Dynamips, also known as “Cisco 7200 Simulator”, achieves simulation by simulating hardware, which is similar to VMware. It also supports NIC bridging mode, thus realize communication with Ethernet cards of the host. With OmniPeek you can s...
CCNA Lab2 Set Router Port Address/Label and Save Settings
Lab Requirements: Lab Requirements: Download address: CCNA lab1 Change Router Name and Password As many customers haved mensioned that there are few lab Q&As in 640-802, here we decide to offer lab video after discussion. You can download them on our website. Currently those lab videos are in preparation. As many customers haved mensioned that there are few lab Q&As in 640-802, here we decide to offer lab video after discussion. You can download them on our website. Currently those lab videos are in preparation. Download: eigrp.zip Lab requirements: enable EIFRP protocol, and ask for entire network accessible Download:nat.zip Lab requirements: configure NAT so that internal network is able to access internet Download:chap.zip Lab requirements: configure CHAP verification Download:pap.zip Lab requirements: configure PAP verification mode PAP unidirectional verification Download:ospf.zip Lab requirements: configure OSPF, and ask for entire network accessible Lab steps:
1. On the router port, set the IP address to 202.119.249.219 and mask to 255.255.255.0.
2. Set the router prompt message to welcome to router CCNAlab.
3 Set the router port prompt message to this is a serial port
CCNA lab1 Change Router Name and Password
1. Router name: router
2. Set password to cisco, sercret to cisco, and vty to cisco.
3 All the passwords are required to be encrypted
CCNA:Lab 2 CDP command operation
For those who are going to tak...
CCNA:lab01 The basic operation of the router
For those who are going to tak...
CCNA:pass4sure cisco lab—EIGRP routing protocol
Lab topology:
Lab steps:
P4S-R1(config)#int lo 0
P4S-R1(config-if)#ip address 10.1.1.1 255.255.255.0
P4S-R1(config-...
CCNA:pass4sure cisco lab NAT configure
Lab topology:
Lab requirements:
PC-1(config)#int f0/0
PC-1(config-if)#ip address 10.1.1.1 255.255.255.0
PC-1(conf...
CCNA:pass4sure cisco lab—configure CHAP verification
Lab topology:
Lab steps:
CHAP unidirectional verification
P4S-R1(config)#int s1/0
P4S-R1(config-if)#clock rate 64000
P4S-R1(config-if)#ip addres...
CCNA:pass4sure cisco lab—configure PAP verification mode
Lab topology:
Lab steps:
P4S-R1(config)#int s1/0
P4S-R1(config-if)#clock rate 64000
P4S-R1(config-if)#ip add...
CCNA:pass4sure cisco lab—OSPF
Lab topology:
P4S-R1(config)#int lo 0
P4S-R1(config-if)#ip address 10.1.1.1 255.255.255.0
P4S-R1(config-if)#no s...